At the end of this session, participants will be able to:
  • Identify each symbol applied to a feature of size
  • Describe the tolerance zone when applied to a feature of size
  • Interpret feature control frames using these symbols
  • Determine if other GD&T symbols are overlapped with a given symbol
  • Apply these symbols to a simple part based on design requirements

Content:
  • Straightness
  • Flatness
  • Perpendicularity
  • Parallelism
  • Angularity
  • Position
  • Concentricity
  • Symmetry
  • Practice exercises
  • Wrap-up

Who Should Attend:
  • Manufacturing engineers
  • Product engineers
  • Design engineers
  • Machinists
  • Quality personnel

Training Session Information
Date Presented:
April 12, 2013 2:00 PM Eastern
Length:
1 hour, 30 minutes
Introduction to GD&T: Tolerances Applied to a Feature of Size
Speaker Information
John-Paul Belanger   [ view bio ]
Individual topic purchase: Selected
SME
Recertification Credit : 1.00
This session is available as recertification credit for individuals who have earned a SME certification.
Preview
Preview Introduction to GD&T: Tolerances Applied to a Feature of SizePreview Introduction to GD&T: Tolerances Applied to a Feature of Size
Subscription
You must be logged in to access Tooling U-SME Subscriptions.
To continue, you need to log in to Peach New Media. If you have any questions about your account please contact us at 1-866-702-3278.
Email Address:
Password:
Products
Streaming
SME Member Price: $89.00
Non-Member Price:$109.00