Introduction to GD&T: Tolerances Applied to a Feature of Size
At the end of this session, participants will be able to:
  • identify each symbol applied to a feature of size
  • describe the tolerance zone when applied to a feature of size
  • interpret feature control frames using these symbols
  • determine if other GD&T symbols are overlapped with a given symbol
  • apply these symbols to a simple part based on design requirements

Content:
  • Straightness
  • Flatness
  • Perpendicularity
  • Parallelism
  • Angularity
  • Position
  • Concentricity
  • Symmetry
  • Practice exercises
  • Wrap-up

Who Should Attend:
  • Manufacturing engineers
  • Product engineers
  • Design engineers
  • Machinists
  • Quality personnel

Training Session Information
Date Presented:
October 26, 2012 2:00 PM Eastern
Length:
1 hour, 30 minutes
Introduction to GD&T: Tolerances Applied to a Feature of Size
Speaker Information
John-Paul Belanger   [ view bio ]
Individual topic purchase: Selected
Society of Manufacturing Engineers
Recertification Credit : 1.00
This session is available as recertification credit for individuals who have earned a SME certification.
Introduction to GD&T: Tolerances Applied to a Feature of Size
Preview
Preview Introduction to GD&T: Tolerances Applied to a Feature of SizePreview Introduction to GD&T: Tolerances Applied to a Feature of Size
Subscription
You must be logged in to access SME Subscriptions.
To continue, you need to login to "Peach New Media". If you have any questions about your account please contact us at 1-866-702-3278
Email Address:
Password:
Products
Streaming
SME Member Price: $110.00
Non-Member Price: $125.00